ALPHA600-10键

  • 产品详情
  • 产品参数

Alpha

产品介绍


发射器与接收机配对

1、发射器配发射器

Paring of transmitters

注:以下两个发射器分别引用“A发射器”和“B发射器”

Note: The following two transmitters are represented as“Transmitter A”,and“Transmitter B”rrespectively

1.“A发射器”装入电池,按下急停开关,让急停处于断开状态;

Install a battery into“Transmitter A”,press the emergency stop switch and keep it power -off;

2.按下“启动按键”(按着不松开);

Press the“START”(hold down);

3.连续按“上键”5次,直到运行指示灯(绿灯)闪烁。此时发射处于主动发射配对模式;

Press“UP” for consecutive 5 times till the operation ind icators(green light)flicker The transmitter is in active tran smission pairing mode at the moment;

4.“B发射器”装入电池,按下急停开关,让急停处于断开状态;

Inslall a ballery in “Transrmiller B",press he errergency stop switch and keep it powerofft;

5.按下“启动按键”(按着不松开);

Press the“START”(hold down);

6.连续按“下键”5次,直到运行指示灯(红灯)常亮。此时发射处

于主动接收配对模式:

Press“DOWN”for consecutive 5 times till the operation indicators(red light) always bright The transmitter is in ac tive receiving pairing mode at the moment;

7.等两个发射器指示灯都熄灭。(此时配对成功)

Wait unitl both transmitter lights go off.(pairing is successful)

▲发射器配接收机

▲Pairing of transmitter and receiver

1.“发射器”装入电池,按下急停开关,让急停处于

Install a battery in 'transmitter” press the emergency stop switch and keep it

断开状态;按下“启动按键”(按着不松开);

power-off;Press the“START”(hold down);

2.连续按“下键”5次,直到运行指示灯(红灯)常亮。此时发射处

于主动接收配对模式;

Press“DOWN”for consecutive 5 times till the operation indicators(red light) always bright The transmitter is in ac tive receiving pairing mode at the moment;

3.开启接收机电源,接收机会自动发射5秒的配对信号;

After powering on,the receiver will transmit pairing signals for 5s automatically;

4.等发射器信号灯熄灭。(此时配对成功)

Wait for transmitter light to go off (pairing successful).


操作步骤

注:请遵照以下操作步骤

Note: Please observe the following operation steps

1.请确认发射器内部电池饱满,接收机以上电;

Confirm the transmitter battery is full and the receiver is powered on;

2.顺时针旋转红色急停开关;

Clockwise rotate the red emergency stop switch;

3.按“START”启动键开机;

Press“START” to power on;

4.按照相关方向操作遥控动作;

Operate the remote control by pressing direction keys;

5.操作结束后,应按停止键停止接收机。

After operation,press“STOP” to stop the receiver

6.将红色急停开关压下置于(OFF)状态,关闭接收机电源。

Shift the red emergency stop switchto“OFF”to power off the receiver.

注:当发生紧急情况时,请执行第“5”和第“6”操作,需要时通知经销商或拨打本公司的技术支持电话,寻求帮助。

Note: In emergency case, please operate according to“5 and“6”; if necessary, report to the dealer or call our technical support number for solution.


Alpha

规格参数

微信截图_20230828153507.png


Alpha

简易故障排除


1、当遥控器不能动作时,请按照以下步骤检查故障

When remote control fails to act please check in following steps:

2、请确认发射器和接收机的地址码和无线频道是否一致;

▲Please confirm whether the address code and wireless channel of transmitter and receiver are consistent;

3、请确认接收机电源是否正常

▲Please contirm whether the power supply of receiver is normal or not;

4、按着启动键,观察指示灯是否正常的绿色闪烁,如果红灯常亮,表示电池欠压,应更换电池;

Hold down“START"and observe whether the green indicator of transmitter flashes; if the red light is normally-on,it indicates the battery is under-voltage, please

change it;

5、如果一切正常遥控仍没有动作,请与经销商联系,或拨打公司技术电话。

AIf there is no fault but the remote control fails to act, please contact with the dealer or call our technical support number.


Alpha

注意事项


1、未经专业培训,不得拆开本机器,否则后果自负;

▲Do not disassemble the machine without professional training,or suffer the consequences;

2、发射器和接收机的地址码和无线频道必须一致才能使用;

▲The transmitter and receiver can be used together only when the address code and wireless channel are consistent;

3、接收机安装位置必须远离变频器、电动机及其链接电缆至少3米以上距离,以避免接收机收到无关信号的干扰;

▲To avoid interference from irrelevant signals the receiver shall be installed at least 3m away from frequency converter, motor and connecting cables;

4、接收机不可安装在电控箱内,正确的安装方式是将接收机固定在电控箱外部的适当位置,然后再将接收机输出电缆穿入控电箱内做适当的接线;

▲The receiver shall not be installed inside the electric control cabinet, but fixed in a suitable position outside, and the out-put cable shall be penetrated into cabinet as a flexible wire;

5、200米范围内不可使用相同无线频道的设备,以避免无线信号相互干扰;

▲To avoid radio interference equipment in same wireless channel shall not be used within 200m;

6、使用设备应具备电源总停接触器、限位开关等安全设施;

The equipment shall be equipped with safety facilities such as master stop contactor and limit switch.

7、使用完毕后应先将遥控器的总停按键按下,然后将急停开关按下。后应关闭行车总电源,以切断接收机电源。

▲After using, press the master stop button of remote controller,then press the emergency stop switch.F inally, turn off the main power of crane and power off the receiver.



Alpha

产品细节图


10-5.jpg


频率范围
848.15MHz-868.15MHz
频道间隔
200K
防水性
IP-66
反应时间
20ms
输出容量
250V @ 10A
发射器电压
DC3.0V